DLS A5 Specifications download pdf (Page 6)

XM20

Speaker wiring XM20

Two fullrange speakers to channel 1 / 2

One 4 ohm subwoofer bridged

For power wiring, see page 3-4

For high or low level input wiring, see page 4

NOTE!

Minimum amplifier load is 2 ohm in stereo mode,

lower impedances may damage the amplifier.

NOTE!

Minimum speaker impedance in bridged connec-

tion is 4 ohm, this connection gives a 2 ohm load

with a 4 ohm subwoofer (the load is halved when

connected in bridge mode).

Do NOT use subwoofers with lower impedance

than 4 ohm. Connect speaker + to CH2+ and

speaker - to CH1

Filter settings CH 1/2 for 2-channel stereo use

The high pass filter (HPF)

blocks very low frequencies

from reaching the spea-

kers. It is mostly used to

protect small speakers ( like

5 inch and smaller ) from

deep bass.

Set the swich in position HPF to activate the filter.

Adjust with the HPF control after your own taste,

a normal setting is 50 - 70 Hz.

The filter can be set at FULL position if you want to

run the amplifier in full range mode without limiting

the frequency range.

Filter settings CH 1/2 for subwoofer use

The low pass filter (LPF)

is mostly used for subwoo-

fers. It will allow low fre-

quencies only and blocks

higher frequencies.

A typical setting is 60 –

70 Hz.

Set the switch to LPF position to activate the filter.

Use this position when conncted to a subwoofer.

Set the switch to FULL position if you want to run

the amplifier in full range mode.

+ CH2 - + CH1 -

50 Hz 500 Hz

FILTER HPF

HPF FULL LPF

+ CH2 - + CH1 -

- +

50 Hz 500 Hz

HPF FULL LPF

LPF FILTER

BRIDGEABLE

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

DLS A5 Specifications Page 6

Comments to this Manuals

Related products and manuals for Car audio amplifiers DLS A5