DLS CA51 Specifications download pdf (Page 6)

Testing

Before you finish the installation, you should do the

following tests to make sure the wiring is correct and

everything is operating properly.

Reconnect Battery

When wiring is complete,

reconnect the battery

negative terminal.

Test speaker connections

Make sure the speakers are connected right. Use

the balance control on the head unit to make sure

right channel is on right speaker etc. If speakers

don´t play at all, one or both speaker wires may

be disconnected.

Test power wiring

1. Turn on the head unit but do not turn up the

volume. The amplifier power light should

come on. If not, check the remote and +12

volt wires. Also check the ground

connection.

2. Turn up the head units volume slightly. All

speakers should operate. if not, check wiring

connections at amplifier and speakers.

Speaker wiring CA 10

Two 2 ohm subwoofers

2 ohm load

One 4 ohm subwoofer

4 ohm load

The Subsonic filter in ON-position and the LPF fil-

ter setting at 60-80 Hz.

Filter settings

CA10

Speaker

+ + - -

Speaker

+ + - -

LPF

40Hz 125Hz

Subsonic

Off On

Four 4 ohm subwoofers

1 ohm load

Speaker

+ + - -

30A

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

DLS CA51 Specifications Page 6

Comments to this Manuals

Related products and manuals for Car audio amplifiers DLS CA51