How to install and operate the DLS CA10,mono amplifier.Welcome!This owners manual is written in easy english anduses a lot of drawings to simply the i
CA10 include RCA input Continuos variable low pass crossover Bass boost feature with remote control Remote turn on / off Phase control continuou
Tools and material neededTools: Flat and Phillips screwdrivers Wire cutter Wire stripper Electric drill with drills Crimping
WiringPower and OutputsCA10Power terminal ( +12V)Ground Terminal ( GND )+12V REM GNDRemote terminal ( REM )For RCA cable signal input:Connect the
Low level inputUse a pair of shielded stereo audio cables with RCAtype jack. Most trunk-mount amplifiers need a 20feet RCA cable ( appr 5 – 6meters).
TestingBefore you finish the installation, you should do thefollowing tests to make sure the wiring is correct andeverything is operating properly.Rec
NOISE PROBLEMSWHINING NOISE VARYING WITH ENGINEREVOLUTIONS:Do this:1. Rewire the power supply (12 V) to sourceunit direct from battery.2. Rewire groun
DLS Svenska ABP.O. Box 13029Artillerigatan 25S-40251 Göteborg, SwedenTel: +46 31 840060Fax: +46 31 844021E-mail: [email protected]
Comments to this Manuals